Repairs
Repair & Maintenance
Most calls in this group start with a description rather than a diagnosis. The door is slow. The door is loud. The door lets in the snow. We take the description, find the part behind it, and fix that.
Which one do I need?
- Your toddler has discovered the wall button.Garage Door Safety Inspection
- Halfway up, the door shudders.Garage Door Tune-Up
- You tapped the door with the bumper while backing in, barely a nudge, and now the bottom corner has swung inward.Off-Track Garage Door Reset
- From outside, the horizontal groove between two sections now steps sideways by a centimetre.Garage Door Panel Replacement
- The gap under the door is a finger wide at one end and nothing at the other.Garage Door Bottom Seal Replacement
- After a windy night there is a fine ridge of snow on the garage floor along one side of the door, and another across the top step.Garage Door Perimeter Weatherstrip
Repair & Maintenance
Inspection, adjustment, sealing, and section-level repairs.
Garage Door Safety Inspection
Springs, cables and drums, looked at and left alone
The counterbalance gets a careful look and nothing more during the inspection. On a torsion door the technician checks the spring coil for a gap, rust or a stretched section, confirms the cone set screws and centre bearing look sound, and follows each cable from the drum to the bottom bracket looking for broken wires, a rust bloom near the loop or a slack side. The drum wrap is checked for a single neat layer.
On an extension door the springs, pulleys and containment cables are examined the same way. Any adjustment to these parts is a separate, planned job matched to that system, torsion tension controlled with winding bars rather than simply released; the inspection records their condition.